Tweet
04-29-2012, 11:41 AM
bcarlson | Hartzell Polished Spinner For Sale
For sale is a polished Hartzell Spinner part number C3532-5P serial number AC-6464 Rev. AP.
This spinner fits Hartzell three blade props, is 13-5/8 inches in diameter at the base, and 17 inches long.
This spinner was purchased for use on a Seawind experimental aircraft, but is also used on Moony, Piper, Beechcraft, Van’s, and many others. It is the responsibility of the buyer to determine their actual application. The Hartzell application list can be found at "Hartzellprop dot com" website by searching for Manual 159.
This spinner can be used on a Seawind, but it requires that the diameter of the opening in the cowling behind the spinner be reduced from about 15 inches to about 13-5/8 inches. This model of spinner was used on Seawind N369JB (shown in photo) and others.
Please note that this spinner has never been installed or tampered with and is in new condition. It is a polished spinner but appears to be dull in the photos because it is covered with a rubberized protective finish as applied by the manufacturer.
This spinner lists for about $1300 but I will sell it for $850 or other reasonable offer. The buyer will pay actual shipping via UPS ground. Interested buyers can email me at "carlsonb at webpipe dot net" or call me at 801-710-5086. Thank you for looking. Best regards, Brent
bcarlson | Hartzell Polished Spinner For Sale
For sale is a polished Hartzell Spinner part number C3532-5P serial number AC-6464 Rev. AP.
This spinner fits Hartzell three blade props, is 13-5/8 inches in diameter at the base, and 17 inches long.
This spinner was purchased for use on a Seawind experimental aircraft, but is also used on Moony, Piper, Beechcraft, Van’s, and many others. It is the responsibility of the buyer to determine their actual application. The Hartzell application list can be found at "Hartzellprop dot com" website by searching for Manual 159.
This spinner can be used on a Seawind, but it requires that the diameter of the opening in the cowling behind the spinner be reduced from about 15 inches to about 13-5/8 inches. This model of spinner was used on Seawind N369JB (shown in photo) and others.
Please note that this spinner has never been installed or tampered with and is in new condition. It is a polished spinner but appears to be dull in the photos because it is covered with a rubberized protective finish as applied by the manufacturer.
This spinner lists for about $1300 but I will sell it for $850 or other reasonable offer. The buyer will pay actual shipping via UPS ground. Interested buyers can email me at "carlsonb at webpipe dot net" or call me at 801-710-5086. Thank you for looking. Best regards, Brent
Comment