Tweet
03-30-2011, 02:05 AM
mike reibling | Main gear hydraulic ram
Does any one have a line drawing of the main gear Hydraulic rams and or know the size of the oring that fit inside the ram.
Mike
03-30-2011, 11:15 AM
Mike
Mike, I have what you r seeking. When I return home next week I will contact you if u haven't received anything by then
03-30-2011, 02:09 PM
Fred Lohr
if this is one of the hydraulic units made by evansburg tool, you can contact Alan Stadlin at 619 489 7580. If it is one of the earlier units from around 98 or before it was made by "control line". I had the older ones and they had a control line decal on them. ended up replacing one after damaging it and the newer one from evansburg doesnt leak (yet
03-31-2011, 11:51 AM
Mike
That's the name of the guy......evansburg in pa.
mike reibling | Main gear hydraulic ram
Does any one have a line drawing of the main gear Hydraulic rams and or know the size of the oring that fit inside the ram.
Mike
03-30-2011, 11:15 AM
Mike
Mike, I have what you r seeking. When I return home next week I will contact you if u haven't received anything by then
03-30-2011, 02:09 PM
Fred Lohr
if this is one of the hydraulic units made by evansburg tool, you can contact Alan Stadlin at 619 489 7580. If it is one of the earlier units from around 98 or before it was made by "control line". I had the older ones and they had a control line decal on them. ended up replacing one after damaging it and the newer one from evansburg doesnt leak (yet
03-31-2011, 11:51 AM
Mike
That's the name of the guy......evansburg in pa.